In Progress Homesite

• Site Last Updated

• 422 se 01/03/2023
• 623 sw 02/09/2022
• whippletree 117 11/29/2022
• site 4 sycamore 01/19/2023
• 251 whipple 02/07/2023
• yt6jhin 02/14/2023
• 14 whipple 02/20/2023
• 91 whipple 02/20/2023
• 328 03/06/2023
• 75 country elm 03/06/2023
• 100 country elm 03/06/2023
• 123333 04/07/2023
• testing 06/17/2023
• test 06/17/2023

* Data is Autosaved

*Upon submission, the data would not be displayed under the "In Progress" tab

Checklist

Foundation meets minimum HUD and manufacturer installation manual criteria Material in home removed & skirting is laid down Home is positioned properly on pad Piers laid out per manual and correct loading info, no broken blocks Cribbing Setup Properly Leveled to less than 1/4" of variance across all piers Floor, roof and wall fastening complete per installation manual instructions Roof has been inspected / repaired from shipping holes and any damage Furnace cap has been installed PVC drain lines have been connected to sewer with 1/4" / ft slope and cleanout Furnace condensation drain line run to exterior of skirting w/screen Dryer vent has been vented outside of skirt and supported Ground anchor system has been completed and properly tensioned per installation manual Marriage line piers installed as needed (openings 4ft or greater) Skirting, siding soffit and fascia compete on ends if applicable Exterior coach lights installed with bulb Complete detailed fit and finish inspection of interior and exterior for damage and correct as needed Dryer Vented through skirting properly per installation manual Ship lose materials removed and light bulbs installed Mate line doors and trim complete (double wide only) Exterior door adjustments are complete and acceptable. Gas, water, grounding and HVAC crossovers complete (double wide homes only) Shipping materials have been removed and placed in receptacle Exterior of home is clean including removal of all extra materials Rough clean complete including removal of shipping materials Submit any defects including parts needed to complete to the manufacturer.

Comments

Write your comments

Images

Upload Images